Recently Updated Pages
[Peer]
[Peer] is used for defining the VPN settings for a remote node capable of routing traffic for one...
PostDown
The PostDown similar to the others is the inverse of PostUp and will run commands on the successf...
PreDown
The PreDown command is used to run commands on request the tunnel be destroyed/brought down, it's...
PostUp
Similar to Preup PostUp is used to run commands, but PostUp runs after the tunnel is up and runni...
PreUp
PreUp is used to run a command before your tunnel interface is brought up. This command can also ...
MTU
The MTU flag as you would probably guess sets the MTU of the tunnel, it's default is 1420 or what...
Table
The Table flag is crucially important for use with more advanced setups, like passing BGP traffic...
DNS
The DNS config flag sets the DNS servers for use with the tunnel, and is generally set on devices...
PrivateKey
The PrivateKey config option defines the private key for the node you are configuring. Not much e...
Generating a public/private keypair
Generating a public and private key in wireguard is super easy! You'll know how to do it in a mat...
ListenPort
ListenPort is a config option for hard programming a port to bind to, this is typically used on r...
Address
Address This config option defines the addresses for the device being configured. It goes under ...
Packet
a network packet is a formatted unit of data carried by a switching network. A packet consists of...
NAT
NAT stands for Network Address Translation, and it's generally used with regards to allowing a la...
CG-NAT
CG-NAT or Carrier-Grade NAT is a deployment of NAT that is done at the ISP scale, and it's extrem...
Installing pathvector
Installing the pathvector routing platform isn't particularly difficult, but I figured I will mak...
Route48
Route48 is a free service that provides PA IPv6 address space, to anyone signing up with a valid ...
Getting IPv6 from your LIR
Welcome to this new section of Beako Learn! This will explain the general process for getting IPv...
Difference between PA and PI
This page will outline the differences between PA (Provider Allocated) and PI (Provider Independe...
Provider Allocated [PA]
Provider allocated [PA] Space is space that is allocated to you from your LIR or providers stock ...